4 ways to clean your carpets Irvine CA

Specialist carpet cleaning corporations use several carpet cleaning techniques to clean a home’s carpets. Each and every cleaning technique has its personal particular benefits and disadvantages. But how do you select amongst them? Assessment these benefits and drawbacks prior to deciding which system you’d prefer to be made use of to clean your carpet.

Basically, carpet cleaning strategies may possibly be placed in one of two categories: wet cleaning or dry cleaning. Wet cleaning includes hot water extraction and may contain cleaning with an absorbent pad. Dry carpet cleaning requires the use of chemical powders or foams applied by specific machines with counter rotating brushes, pads or cylinders.

1. Wet cleaning
How it performs

Also referred to as hot water extraction or steam cleaning, the carpet is very first pre-conditioned using a chemical reagent that liquefies soils and oil-based substances which might be present inside the carpet fibers. Water is heated to a temperature near its boiling point and pressurized, then injected in to the carpet. Soon after about ten to 15 minutes, the remedy is extracted having a vacuum.
Have to have experienced assistance together with your project?
Get quotes from top-rated pros.


Gets out soiling from deep down in the carpet.

Permits the use of higher temperatures, pressures and chemical concentrates.

Permits extended dwell occasions for reaction of cleaning solvents.

Chemical reactivity facilitated by agitation with grooming tool or extraction wand.

Most widely applied process.

Encouraged by carpet companies and market cleaning specialists and specialists


Relatively extended drying time, but this could be lowered together with the use of potent gear by competent technicians.

Costly gear generally essential for maximum efficiency.

Fairly higher cost components.

2. Cleaning with an absorbent pad
How it

This carpet cleaning approach can also be typically recognized as bonnet cleaning and is most generally made use of for routine light upkeep. It might also be utilized for common carpet cleaning. The carpet is 1st vacuumed, and after that a chemical solution is sprayed on to it using a hand pump or electric sprayer. The answer is permitted to stay on the carpet for a appropriate dwell or reaction time.

The absorbent pad or bonnet, which appears like a towel, is placed on the drive block of a rotary floor machine and spun more than the carpet surface at one hundred to 300 rpm. This action serves to impregnate the carpet fibers using the chemical remedy and after that choose it up with the soils afterward.


Rapid, simple and cheap.

Exceptional results with lightly soiled carpets.


Only cleans the top one-third of carpet fibers, incapable of reaching deeper down.

Leaves dirt and chemical compounds to accumulate in the bottom from the carpet fibers.

3. Dry cleaning with an absorbent compound
How it

A powder that has been mixed with special solvents and cleaning agents is spread more than the carpet, after which worked into the carpet fibers using a machine fitted with counter-rotating brushes. The powder absorbs soils within the carpet fibers. Soon after it’s permitted to set around the carpet for ten to 15 minutes, it is vacuumed up.


Pretty simple method with no specific technical instruction required.

Very rapidly drying, it ordinarily only requires about 20 minutes just before the carpet might be back in service.


Powder may well be trapped in plush pile carpets and left to make up more than time.

May cause excessive dust build-up within the dwelling.

Unable to clean deep down into the carpet.

four. Dry foam or rotary shampoo method
How it

A cleaning agent is applied towards the carpet to help suspend dirt and debris in the carpet, that is then whipped into foam and worked in to the carpet fibers with the rotating brushes of a particular machine. Right after a brief dwell time, the foam is extracted with a vacuum.


Quick, simple to apply and economical.

Rotating brushes provide great agitation.

Small quantity of moisture allows quick drying of carpet.


Unable to achieve thorough soil extraction beneath the surface in the carpet.

High temperatures ordinarily not accomplished.

Excessive wetting doable with gear malfunction.

0 replies

Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply

Your email address will not be published. Required fields are marked *

seventeen − 5 =